The main features
- Peak, Real time and RGmode.(selectable) 
- Programmable High and Low set points with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing.
- The type of series is five kinds.
It is adapted for various torque ranges (0.1 mN-m - 2 N-m).
- External input and output are also substantial.
An OK-NG output and data output External start signal input
- By RG mode (real-time output) loading, a torque wave is also simply with a personal computer.

  Specification　

Specification

NTS-6

S-1

S-2

S-5

S-10

S-20

Measuring range  
(at the time of Track)

3.0～100
mN・m

3.0～200
mN・m

0.030～0.5
N・m

0.030～1
N・m

0.030～2　
N・m

Accuracy

±1　％

2 mN・m　or Less　±3dijit

0.2 N・m　or Less　±3dijit

Rotational frequency
(at the time of no-load)

85ｒｐｍ

25ｒｐｍ

13ｒｐｍ

18ｒｐｍ

18ｒｐｍ

Display

The 4 figures digital display of LCD

The measurement direction

CW-CCW Possible (right and left)   It rotates by the motor.

Measuring 
mode

Peak operation mode (PP): 
Display the maximum under measurement .

Truck mode (GO): 
Always display the load torque which has started.

RG mode (PD): 
Carry out the data output of the load torque every  1/ 87 seconds.

Measurement start time

Time after beginning rotation until it starts measurement is set up 
(0.1 - 1 second).

Torque judging

It is in measuring range and a setup of a maximum value and a minimum value is possible.[ O.K.　Iｎ the Set point ] Lamp lighting  :  [ NG Outside the Set point ] Error buzzer

External input and output

Signal output (open collector): O.K., NG
Data output: ASCII Format (baud rate9600), External start switch input

Power supply

AC100V～240V

bit size

φ 4

HEX6.35

Outside size indicator

165（W）×110（D）×58（H）

Outside size detector

φ28×155

φ37×195

φ40×235

Accessories
(one piece each)

Inspection report, Proofreading certificate, Traceability system figure