Thiết bị kiểm tra lực xoắn Cedar model DIS-RL05

Thiết bị đo lực xoắn Cedar - Thiết kiểm tra lực xoắn Cedar-TORQUE TESTER 

Bolting measurement of screw and bolt

● TORQUE TESTER 　DIS-RL series

Separate type merit!
Detection part is compact.

Yes-no decision conditions etc. can save five channels.
.. A channel is only changed even if bolting conditions change.
It is not necessary to reset up a maximum value and a minimum value one by one like former.

DIS-RL05
To measurement of the minute torque of 500 or less mN-m

Since the detection part was small and a light weight,minute torque measurement which needs prudence for handling was enabled.

DIS-RL2
Measurement to 2N・m

It is easy to use measuring range widely.

DIS-RL6
Measurement to 6 N・m

The main functions　(DIS series)  
□ Yes-no decision　
□ Average calculation
□ Data storage is 800 affairs.
□ A convenient functional setup of a setup of a measurement start value etc.
□ Data output at real time (every about 1/180 seconds).　
□ USB terminal data output

Specification

DIS-RL05

DIS-RL2

DIS-RL6

Measuring range

2.0～500 mN･m
0.020～5 kgf・cm
0.020～4.5 lbf・in

0.010～2 N･m
0.10～20 kgf・cm
0.10～17.4 lbf・in

0.10～6 N･m
1.0～60 kgf・cm
1.0～54lbf・in

Accuracy

±0.5% (or less 499±3digit)

±0.5% (or less 199±1digit)

Display

The 4 figures digital display of LCD

The measurement direction

CW-CCW (right and left)

Measuring 
mode

P-P  Peak

Peak load value hold.

T-R  Track

Indication of real time torque value.

P-D  Peak down

Holding Load Value at the moment to change from upward to downword

C Real-time output

Load torque value is outputted every about1/ 180 second by RS232C.

Decision 
function

Setting of torque value

A top and a minimum value are in a measuring range, and a setup is possible.
Can confirm the set value by the buzzer sound or LED.

The Maximum, the minimum, and the average value

The maximum, the minimum value, and average value of the saved data

clearance

It is a display clearance in set-up time.   (0.5 - 3.0 sec)

One-touch zero

A clear button is pushed and it is a zero. data output.

Data spec.

Data transfer

ASCII format (Baud rate : 19200)

Data memory

800 data stored

Power supply

Ni-Cd chargeable battery 1.2V×4cells 　450mAh

Auto power save

10 minutes no use, automatically switch off.

Charging time

about 3hours

Continunous working time

10 hours

Meter outside type dimension

100(W) x105(D) x40 (H)  (It does not contain by the projection thing.)

Weight

Meter part    520g

Bit/Socket part

Φ4

HEX 6.35

Accessories
 (one piece each)

Φ4 bits
(＋)　♯0/♯1

6.35HEX bits
(＋)　♯1/♯2

Receipt case

AC/DC adaptor

An inspection report, a proofreading certificate, a traceability system figure