Pressure excessive using an orifice effect at a moment
The adjustment-type bumper which relaxes pulsation pressure

　●Use of best pressure /20MPa
　●Withstand pressure examination pressure /30MPa
　●Use fluid / liquid

　Plumbing method example　

1.        The fluid flow is usually cut off because it is tightened は center screw. Please confirm it by a driver for sense. A screw becomes easy to turn を six angles of stuffing nuts when I loosen を to some extent.

2.        The passage opens a screw when I loosen it to を left mawashi. When I turn it and regulate by little so that the touch of the guideline of the gauge becomes the most oppression in a startup in around one second, generally, as for the adjustment, the best suppressant effect is provided for the pulsation pressure.

3.        You gradually tighten it so that pulsatile width becomes small as much as possible from the position that pulsation pressure adjustment lowered at the time of main constituent a little, and please adjust it. The degree to tighten a screw differs by a property of the pitch of a fluid and the pressure or the pulsation pressure, but is within around 0.5-1.5 rounds from the position that I closed. Because you are damaged when it goes back up too much, please be careful.

4.        I put a seal of [please do not touch it for adjustment finished] for を adjustment finished and ship it, but, as for the product which I inserted ダンプナー in between a diaphragm device and gauges, the effect that you should fine-tune in the optimum depending on pulsation width for a pulsation cycle of use ahead may be provided a leading screw beforehand.

5.        Finally a hexagon nut, please tighten を.